3.5 Alternating current versus direct current  (Page 2/10)

We are most often concerned with average power rather than its fluctuations—that 60-W light bulb in your desk lamp has an average power consumption of 60 W, for example. As illustrated in [link] , the average power $P_{\text{ave}}$ is

This is evident from the graph, since the areas above and below the $(1/2)I_0{V}_0$ line are equal, but it can also be proven using trigonometric identities. Similarly, we define an average or rms current     $I_{\text{rms}}$ and average or rms voltage     $V_{\text{rms}}$ to be, respectively,

and

where rms stands for root mean square, a particular kind of average. In general, to obtain a root mean square, the particular quantity is squared, its mean (or average) is found, and the square root is taken. This is useful for AC, since the average value is zero. Now,

which gives

as stated above. It is standard practice to quote $I_{\text{rms}}$ , $V_{\text{rms}}$ , and $P_{\text{ave}}$ rather than the peak values. For example, most household electricity is 120 V AC, which means that $V_{\text{rms}}$ is 120 V. The common 10-A circuit breaker will interrupt a sustained $I_{\text{rms}}$ greater than 10 A. Your 1.0-kW microwave oven consumes $P_{\text{ave}}=\text{1.0 kW}$ , and so on. You can think of these rms and average values as the equivalent DC values for a simple resistive circuit.

To summarize, when dealing with AC, Ohm’s law and the equations for power are completely analogous to those for DC, but rms and average values are used for AC. Thus, for AC, Ohm’s law is written

The various expressions for AC power $P_{\text{ave}}$ are

and

Why use ac for power distribution?

Most large power-distribution systems are AC. Moreover, the power is transmitted at much higher voltages than the 120-V AC (240 V in most parts of the world) we use in homes and on the job. Economies of scale make it cheaper to build a few very large electric power-generation plants than to build numerous small ones. This necessitates sending power long distances, and it is obviously important that energy losses en route be minimized. High voltages can be transmitted with much smaller power losses than low voltages, as we shall see. (See [link] .) For safety reasons, the voltage at the user is reduced to familiar values. The crucial factor is that it is much easier to increase and decrease AC voltages than DC, so AC is used in most large power distribution systems.