<< Chapter < Page Chapter >> Page >

Art connection

Graph plots membrane potential in millivolts versus time. The membrane remains at the resting potential of -70 millivolts until a nerve impulse occurs in step 1. Some sodium channels open, and the potential begins to rapidly climb past the threshold of excitation of -55 millivolts, at which point all the sodium channels open. At the peak action potential, the potential begins to rapidly drop as potassium channels open and sodium channels close. As a result, the membrane repolarizes past the resting membrane potential and becomes hyperpolarized. The membrane potential then gradually returns to normal.
The formation of an action potential can be divided into five steps: (1) A stimulus from a sensory cell or another neuron causes the target cell to depolarize toward the threshold potential. (2) If the threshold of excitation is reached, all Na + channels open and the membrane depolarizes. (3) At the peak action potential, K + channels open and K + begins to leave the cell. At the same time, Na + channels close. (4) The membrane becomes hyperpolarized as K + ions continue to leave the cell. The hyperpolarized membrane is in a refractory period and cannot fire. (5) The K + channels close and the Na + /K + transporter restores the resting potential.

The action potential travels from the soma down the axon to the axon terminal. The action potential is initiated when a signal from the soma causes the soma-end of the axon membrane to depolarize. The depolarization spreads down the axon. Meanwhile, the membrane at the start of the axon repolarizes. Because potassium channels are open, the membrane cannot depolarize again. The action potential continues to spread down the axon this way.
The action potential is conducted down the axon as the axon membrane depolarizes, then repolarizes.

Myelin and the propagation of the action potential

For an action potential to communicate information to another neuron, it must travel along the axon and reach the axon terminals where it can initiate neurotransmitter release. The speed of conduction of an action potential along an axon is influenced by both the diameter of the axon and the axon’s resistance to ion leakage. Myelin acts as an insulator that prevents current from leaving the axon; this increases the speed of action potential conduction. In demyelinating diseases like multiple sclerosis, action potential conduction slows because ions leak from previously insulated axon areas. The nodes of Ranvier, illustrated in [link] are gaps in the myelin sheath along the axon. These unmyelinated spaces are about one micrometer long and contain voltage gated Na + and K + channels. Flow of ions through these channels, particularly the Na + channels, regenerates the action potential over and over again along the axon. This ‘jumping’ of the action potential from one node to the next is called saltatory conduction    . If nodes of Ranvier were not present along an axon, the action potential would propagate very slowly since Na + and K + channels would have to continuously regenerate action potentials at every point along the axon instead of at specific points. Nodes of Ranvier also save energy for the neuron since the channels only need to be present at the nodes and not along the entire axon.

Illustration shows an axon covered in three bands of myelin sheath. Between the sheath coverings the axon is exposed. The uncovered parts of the axon are called nodes of Ranvier. In the illustration, the left node of Ranvier is depolarized such that the membrane potential is positive inside and negative outside. The right membrane of the right node is at the resting potential, negative inside and positive outside. An arrow indicates that the depolarization jumps from the left node to the right, so that the right node becomes depolarized.
Nodes of Ranvier are gaps in myelin coverage along axons. Nodes contain voltage-gated K + and Na + channels. Action potentials travel down the axon by jumping from one node to the next.

Synaptic transmission

The synapse or “gap” is the place where information is transmitted from one neuron to another. Synapses usually form between axon terminals and dendritic spines, but this is not universally true. There are also axon-to-axon, dendrite-to-dendrite, and axon-to-cell body synapses. The neuron transmitting the signal is called the presynaptic neuron, and the neuron receiving the signal is called the postsynaptic neuron. Note that these designations are relative to a particular synapse—most neurons are both presynaptic and postsynaptic. There are two types of synapses: chemical and electrical.

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Human biology. OpenStax CNX. Dec 01, 2015 Download for free at http://legacy.cnx.org/content/col11903/1.3
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Human biology' conversation and receive update notifications?

Ask