<< Chapter < Page | Chapter >> Page > |
From [link] ,
Substituting from above,
For , , and ,
Then, the intensity is
Using for , we find
which is the maximum interference order that fits inside the central peak. We note that are missing orders as matches exactly. Accordingly, we observe bright fringes for
for a total of 19 bright fringes.
Check Your Understanding For the experiment in [link] , show that is also a missing order.
From , the interference maximum occurs at for From [link] , this is also the angle for the second diffraction minimum. ( Note: Both equations use the index m but they refer to separate phenomena.)
Explore the effects of double-slit diffraction. In this simulation written by Fu-Kwun Hwang, select using the slider and see what happens when you control the slit width, slit separation and the wavelength. Can you make an order go “missing?”
Shown below is the central part of the interference pattern for a pure wavelength of red light projected onto a double slit. The pattern is actually a combination of single- and double-slit interference. Note that the bright spots are evenly spaced. Is this a double- or single-slit characteristic? Note that some of the bright spots are dim on either side of the center. Is this a single- or double-slit characteristic? Which is smaller, the slit width or the separation between slits? Explain your responses.
Two slits of width each in an opaque material, are separated by a center-to-center distance of A monochromatic light of wavelength 450 nm is incident on the double-slit. One finds a combined interference and diffraction pattern on the screen.
(a) How many peaks of the interference will be observed in the central maximum of the diffraction pattern?
(b) How many peaks of the interference will be observed if the slit width is doubled while keeping the distance between the slits same?
(c) How many peaks of interference will be observed if the slits are separated by twice the distance, that is, while keeping the widths of the slits same?
(d) What will happen in (a) if instead of 450-nm light another light of wavelength 680 nm is used?
(e) What is the value of the ratio of the intensity of the central peak to the intensity of the next bright peak in (a)?
(f) Does this ratio depend on the wavelength of the light?
(g) Does this ratio depend on the width or separation of the slits?
A double slit produces a diffraction pattern that is a combination of single- and double-slit interference. Find the ratio of the width of the slits to the separation between them, if the first minimum of the single-slit pattern falls on the fifth maximum of the double-slit pattern. (This will greatly reduce the intensity of the fifth maximum.)
0.200
For a double-slit configuration where the slit separation is four times the slit width, how many interference fringes lie in the central peak of the diffraction pattern?
Light of wavelength 500 nm falls normally on 50 slits that are wide and spaced apart. How many interference fringes lie in the central peak of the diffraction pattern?
3
A monochromatic light of wavelength 589 nm incident on a double slit with slit width and unknown separation results in a diffraction pattern containing nine interference peaks inside the central maximum. Find the separation of the slits.
When a monochromatic light of wavelength 430 nm incident on a double slit of slit separation there are 11 interference fringes in its central maximum. How many interference fringes will be in the central maximum of a light of wavelength 632.8 nm for the same double slit?
9
Determine the intensities of two interference peaks other than the central peak in the central maximum of the diffraction, if possible, when a light of wavelength 628 nm is incident on a double slit of width 500 nm and separation 1500 nm. Use the intensity of the central spot to be .
Notification Switch
Would you like to follow the 'University physics volume 3' conversation and receive update notifications?