<< Chapter < Page Chapter >> Page >
By the end of this section, you will be able to:
  • State the forces that act on a simple pendulum
  • Determine the angular frequency, frequency, and period of a simple pendulum in terms of the length of the pendulum and the acceleration due to gravity
  • Define the period for a physical pendulum
  • Define the period for a torsional pendulum

Pendulums are in common usage. Grandfather clocks use a pendulum to keep time and a pendulum can be used to measure the acceleration due to gravity. For small displacements, a pendulum is a simple harmonic oscillator.

The simple pendulum

A simple pendulum    is defined to have a point mass, also known as the pendulum bob , which is suspended from a string of length L with negligible mass ( [link] ). Here, the only forces acting on the bob are the force of gravity (i.e., the weight of the bob) and tension from the string. The mass of the string is assumed to be negligible as compared to the mass of the bob.

In the figure, a horizontal bar is shown. A string of length L extends from the bar at an angle theta counterclockwise from the vertical. The vertical direction is indicated by a dashed line extending down from where the string is attached to the bar. A circular bob of mass m is attached to the lower end of the string. The arc from the mass to the vertical is indicated by another dashed line and is a length s. A red arrow showing the time T of the oscillation of the mob is shown along the string line toward the bar. A coordinate system is shown near the bob with the positive y direction aligned with the string and pointing toward the pivot point and the positive x direction pointing tangent to the arc and away from the equilibrium position. An blue arrow from the bob toward the pivot, along the string, is labeled F sub T. A red arrow from the bob pointing down is labeled w = m g. A red arrow pointing tangent to the arc and toward equilibrium, in the minus x direction, is labeled minus m g sine theta. A red arrow at an angle theta counterclockwise from w is labeled minus m g cosine theta.
A simple pendulum has a small-diameter bob and a string that has a very small mass but is strong enough not to stretch appreciably. The linear displacement from equilibrium is s , the length of the arc. Also shown are the forces on the bob, which result in a net force of m g sin θ toward the equilibrium position—that is, a restoring force.

Consider the torque on the pendulum. The force providing the restoring torque is the component of the weight of the pendulum bob that acts along the arc length. The torque is the length of the string L times the component of the net force that is perpendicular to the radius of the arc. The minus sign indicates the torque acts in the opposite direction of the angular displacement:

τ = L ( m g sin θ ) ; I α = L ( m g sin θ ) ; I d 2 θ d t 2 = L ( m g sin θ ) ; m L 2 d 2 θ d t 2 = L ( m g sin θ ) ; d 2 θ d t 2 = g L sin θ .

The solution to this differential equation involves advanced calculus, and is beyond the scope of this text. But note that for small angles (less than 15 degrees), sin θ and θ differ by less than 1%, so we can use the small angle approximation sin θ θ . The angle θ describes the position of the pendulum. Using the small angle approximation gives an approximate solution for small angles,

d 2 θ d t 2 = g L θ .

Because this equation has the same form as the equation for SHM, the solution is easy to find. The angular frequency is

ω = g L

and the period is

T = 2 π L g .

The period of a simple pendulum depends on its length and the acceleration due to gravity. The period is completely independent of other factors, such as mass and the maximum displacement. As with simple harmonic oscillators, the period T for a pendulum is nearly independent of amplitude, especially if θ is less than about 15 ° . Even simple pendulum clocks can be finely adjusted and remain accurate.

Note the dependence of T on g . If the length of a pendulum is precisely known, it can actually be used to measure the acceleration due to gravity, as in the following example.

Measuring acceleration due to gravity by the period of a pendulum

What is the acceleration due to gravity in a region where a simple pendulum having a length 75.000 cm has a period of 1.7357 s?

Strategy

We are asked to find g given the period T and the length L of a pendulum. We can solve T = 2 π L g for g , assuming only that the angle of deflection is less than 15 ° .

Solution

  1. Square T = 2 π L g and solve for g :
    g = 4 π 2 L T 2 .
  2. Substitute known values into the new equation:
    g = 4 π 2 0.75000 m ( 1.7357 s ) 2 .
  3. Calculate to find g :
    g = 9.8281 m/s 2 .

Significance

This method for determining g can be very accurate, which is why length and period are given to five digits in this example. For the precision of the approximation sin θ θ to be better than the precision of the pendulum length and period, the maximum displacement angle should be kept below about 0.5 ° .

Got questions? Get instant answers now!

Questions & Answers

if three forces F1.f2 .f3 act at a point on a Cartesian plane in the daigram .....so if the question says write down the x and y components ..... I really don't understand
Syamthanda Reply
hey , can you please explain oxidation reaction & redox ?
Boitumelo Reply
hey , can you please explain oxidation reaction and redox ?
Boitumelo
for grade 12 or grade 11?
Sibulele
the value of V1 and V2
Tumelo Reply
advantages of electrons in a circuit
Rethabile Reply
we're do you find electromagnetism past papers
Ntombifuthi
what a normal force
Tholulwazi Reply
it is the force or component of the force that the surface exert on an object incontact with it and which acts perpendicular to the surface
Sihle
what is physics?
Petrus Reply
what is the half reaction of Potassium and chlorine
Anna Reply
how to calculate coefficient of static friction
Lisa Reply
how to calculate static friction
Lisa
How to calculate a current
Tumelo
how to calculate the magnitude of horizontal component of the applied force
Mogano
How to calculate force
Monambi
a structure of a thermocouple used to measure inner temperature
Anna Reply
a fixed gas of a mass is held at standard pressure temperature of 15 degrees Celsius .Calculate the temperature of the gas in Celsius if the pressure is changed to 2×10 to the power 4
Amahle Reply
How is energy being used in bonding?
Raymond Reply
what is acceleration
Syamthanda Reply
a rate of change in velocity of an object whith respect to time
Khuthadzo
how can we find the moment of torque of a circular object
Kidist
Acceleration is a rate of change in velocity.
Justice
t =r×f
Khuthadzo
how to calculate tension by substitution
Precious Reply
hi
Shongi
hi
Leago
use fnet method. how many obects are being calculated ?
Khuthadzo
khuthadzo hii
Hulisani
how to calculate acceleration and tension force
Lungile Reply
you use Fnet equals ma , newtoms second law formula
Masego
please help me with vectors in two dimensions
Mulaudzi Reply
how to calculate normal force
Mulaudzi
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 3

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, University physics volume 1. OpenStax CNX. Sep 19, 2016 Download for free at http://cnx.org/content/col12031/1.5
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'University physics volume 1' conversation and receive update notifications?

Ask