<< Chapter < Page Chapter >> Page >
The motion of the projectile has an arched trajectory due to gravity.

The span of projectile motion in the vertical plane is determined by two factors, namely the speed of projection and angle of projection with respect to horizontal. These two factors together determine (i) how long does the projectile remain in air (time of flight, T) (ii) how far does the projectile go in the horizontal direction (range of projectile, R) and (iii) how high does the projectile reach (maximum height, H).

Further, the trajectory of the projectile is symmetric about a vertical line passing through the point of maximum height if point of projection and point of return fall on the same horizontal surface.

Time of flight, t

We have already determined the time of flight, which is given by :

T = 2 u y g = 2 u sin θ g

This equation was derived in the earlier module Projectile motion with the assumption that both point of projection and point of return of the projectile lie on same horizontal level. It may be also be recalled that the equation of motion in vertical direction was evaluated for the condition that net displacement during the entire motion is zero. Hence, if the points are not on the same level, then above equation will not be valid and must be determined by equation of motion for the individual case with appropriate values.

From the above equation, we see that time of flight depends on initial speed and the angle of projection (θ). We must realize here that the range of θ is 0° ≤ θ ≤ 90°. For this range, sinθ is an increasing function. As such, we can say that a projection closer to vertical direction stays longer in the air for a given initial velocity. As a matter of fact, a vertical projectile for which θ = 90° and sinθ = 1, stays in the air for the maximum period.

If the points of projection and return are on same level and air resistance is neglected, which of the following quantities will enable determination of the total time of flight (T) :

(a) horizontal component of projection velocity

(b) projection speed and angle of projection

(c) vertical component of projection velocity

(d) speed at the highest point

The total time of flight is given by :

T = 2 u y g = 2 u sin θ g

We can see that the total time of flight can be determined if vertical component of the velocity ( u y ) is given. Hence option (c) is correct. The vertical component of the velocity ( u y ) , in turn, is determined by the projection speed (u) and angle of projection ( θ ). Hence option (b) is correct.

Now speed at the highest point is equal to the horizontal component of projection velocity (u cos θ ). We can not, however, determine vertical component (u sin θ ) from this value, unless either "u" or " θ " is also given.

Hence, options (b) and (c) are correct.

Note: We have noticed that time of flight is derived considering vertical motion. Horizontal part of the motion is not considered. Thus, the time of flight (t) at any point during the projectile motion is dependent on vertical component of velocity or vertical part of the motion and is independent of horizontal part of the motion.

Got questions? Get instant answers now!

Questions & Answers

Three charges q_{1}=+3\mu C, q_{2}=+6\mu C and q_{3}=+8\mu C are located at (2,0)m (0,0)m and (0,3) coordinates respectively. Find the magnitude and direction acted upon q_{2} by the two other charges.Draw the correct graphical illustration of the problem above showing the direction of all forces.
Kate Reply
To solve this problem, we need to first find the net force acting on charge q_{2}. The magnitude of the force exerted by q_{1} on q_{2} is given by F=\frac{kq_{1}q_{2}}{r^{2}} where k is the Coulomb constant, q_{1} and q_{2} are the charges of the particles, and r is the distance between them.
Muhammed
What is the direction and net electric force on q_{1}= 5µC located at (0,4)r due to charges q_{2}=7mu located at (0,0)m and q_{3}=3\mu C located at (4,0)m?
Kate Reply
what is the change in momentum of a body?
Eunice Reply
what is a capacitor?
Raymond Reply
Capacitor is a separation of opposite charges using an insulator of very small dimension between them. Capacitor is used for allowing an AC (alternating current) to pass while a DC (direct current) is blocked.
Gautam
A motor travelling at 72km/m on sighting a stop sign applying the breaks such that under constant deaccelerate in the meters of 50 metres what is the magnitude of the accelerate
Maria Reply
please solve
Sharon
8m/s²
Aishat
What is Thermodynamics
Muordit
velocity can be 72 km/h in question. 72 km/h=20 m/s, v^2=2.a.x , 20^2=2.a.50, a=4 m/s^2.
Mehmet
A boat travels due east at a speed of 40meter per seconds across a river flowing due south at 30meter per seconds. what is the resultant speed of the boat
Saheed Reply
50 m/s due south east
Someone
which has a higher temperature, 1cup of boiling water or 1teapot of boiling water which can transfer more heat 1cup of boiling water or 1 teapot of boiling water explain your . answer
Ramon Reply
I believe temperature being an intensive property does not change for any amount of boiling water whereas heat being an extensive property changes with amount/size of the system.
Someone
Scratch that
Someone
temperature for any amount of water to boil at ntp is 100⁰C (it is a state function and and intensive property) and it depends both will give same amount of heat because the surface available for heat transfer is greater in case of the kettle as well as the heat stored in it but if you talk.....
Someone
about the amount of heat stored in the system then in that case since the mass of water in the kettle is greater so more energy is required to raise the temperature b/c more molecules of water are present in the kettle
Someone
definitely of physics
Haryormhidey Reply
how many start and codon
Esrael Reply
what is field
Felix Reply
physics, biology and chemistry this is my Field
ALIYU
field is a region of space under the influence of some physical properties
Collete
what is ogarnic chemistry
WISDOM Reply
determine the slope giving that 3y+ 2x-14=0
WISDOM
Another formula for Acceleration
Belty Reply
a=v/t. a=f/m a
IHUMA
innocent
Adah
pratica A on solution of hydro chloric acid,B is a solution containing 0.5000 mole ofsodium chlorid per dm³,put A in the burret and titrate 20.00 or 25.00cm³ portion of B using melting orange as the indicator. record the deside of your burret tabulate the burret reading and calculate the average volume of acid used?
Nassze Reply
how do lnternal energy measures
Esrael
Two bodies attract each other electrically. Do they both have to be charged? Answer the same question if the bodies repel one another.
JALLAH Reply
No. According to Isac Newtons law. this two bodies maybe you and the wall beside you. Attracting depends on the mass och each body and distance between them.
Dlovan
Are you really asking if two bodies have to be charged to be influenced by Coulombs Law?
Robert
like charges repel while unlike charges atttact
Raymond
What is specific heat capacity
Destiny Reply
Specific heat capacity is a measure of the amount of energy required to raise the temperature of a substance by one degree Celsius (or Kelvin). It is measured in Joules per kilogram per degree Celsius (J/kg°C).
AI-Robot
specific heat capacity is the amount of energy needed to raise the temperature of a substance by one degree Celsius or kelvin
ROKEEB
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Physics for k-12. OpenStax CNX. Sep 07, 2009 Download for free at http://cnx.org/content/col10322/1.175
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Physics for k-12' conversation and receive update notifications?

Ask