<< Chapter < Page Chapter >> Page >

A full-term fetus typically has a mass of 3.50 kg. (a) What pressure does the weight of such a fetus create if it rests on the mother’s bladder, supported on an area of 90 . 0 cm 2 size 12{"90" "." 0`"cm" rSup { size 8{2} } } {} ? (b) Convert this pressure to millimeters of mercury and determine if it alone is great enough to trigger the micturition reflex (it will add to any pressure already existing in the bladder).

(a) 3 . 81 × 10 3 N/m 2 size 12{3 "." "81" times "10" rSup { size 8{3} } `"N/m" rSup { size 8{2} } } {}

(b) 28.7 mm Hg size 12{"28" "." 7`"mm"`"Hg"} {} , which is sufficient to trigger micturition reflex

If the pressure in the esophagus is 2.00 mm Hg size 12{ - 2 "." "00"`"mm"`"Hg"} {} while that in the stomach is + 20.0 mm Hg size 12{+"20" "." 0`"mm"`"Hg"} {} , to what height could stomach fluid rise in the esophagus, assuming a density of 1.10 g/mL? (This movement will not occur if the muscle closing the lower end of the esophagus is working properly.)

Pressure in the spinal fluid is measured as shown in [link] . If the pressure in the spinal fluid is 10.0 mm Hg: (a) What is the reading of the water manometer in cm water? (b) What is the reading if the person sits up, placing the top of the fluid 60 cm above the tap? The fluid density is 1.05 g/mL.

Diagram of a person lying face-down on a table hooked up to a medical apparatus. A needle attached to a tube is inserted between the patient’s vertebrae in the lower back area. The tube, which appears to be filled with fluid, is connected to an upright tube containing an unknown amount of water. The height of the water in the tube is labeled question-mark centimeters H 2 O. A label pointing to the patient’s head reads P equals ten millimeters H g.
A water manometer used to measure pressure in the spinal fluid. The height of the fluid in the manometer is measured relative to the spinal column, and the manometer is open to the atmosphere. The measured pressure will be considerably greater if the person sits up.

(a) 13.6 m water

(b) 76.5 cm water

Calculate the maximum force in newtons exerted by the blood on an aneurysm, or ballooning, in a major artery, given the maximum blood pressure for this person is 150 mm Hg and the effective area of the aneurysm is 20 . 0 cm 2 size 12{"20" "." 0`"cm" rSup { size 8{2} } } {} . Note that this force is great enough to cause further enlargement and subsequently greater force on the ever-thinner vessel wall.

During heavy lifting, a disk between spinal vertebrae is subjected to a 5000-N compressional force. (a) What pressure is created, assuming that the disk has a uniform circular cross section 2.00 cm in radius? (b) What deformation is produced if the disk is 0.800 cm thick and has a Young’s modulus of 1 . 5 × 10 9 N/m 2 size 12{1 "." 5 times "10" rSup { size 8{9} } `"N/m" rSup { size 8{2} } } {} ?

(a) 3 . 98 × 10 6 Pa size 12{3 "." "98" times "10" rSup { size 8{6} } `"Pa"} {}

(b) 2 . 1 × 10 3 cm size 12{2 "." 1 times "10" rSup { size 8{ - 3} } `"cm"} {}

When a person sits erect, increasing the vertical position of their brain by 36.0 cm, the heart must continue to pump blood to the brain at the same rate. (a) What is the gain in gravitational potential energy for 100 mL of blood raised 36.0 cm? (b) What is the drop in pressure, neglecting any losses due to friction? (c) Discuss how the gain in gravitational potential energy and the decrease in pressure are related.

(a) How high will water rise in a glass capillary tube with a 0.500-mm radius? (b) How much gravitational potential energy does the water gain? (c) Discuss possible sources of this energy.

(a) 2.97 cm

(b) 3 . 39 × 10 6 J size 12{3 "." "39" times "10" rSup { size 8{ - 6} } `J} {}

(c) Work is done by the surface tension force through an effective distance h / 2 size 12{h/2} {} to raise the column of water.

A negative pressure of 25.0 atm can sometimes be achieved with the device in [link] before the water separates. (a) To what height could such a negative gauge pressure raise water? (b) How much would a steel wire of the same diameter and length as this capillary stretch if suspended from above?

When the piston is raised the liquid separates and results in negative pressure.
(a) When the piston is raised, it stretches the liquid slightly, putting it under tension and creating a negative absolute pressure P = F / A size 12{P= - F/A} {} (b) The liquid eventually separates, giving an experimental limit to negative pressure in this liquid.

Suppose you hit a steel nail with a 0.500-kg hammer, initially moving at 15.0 m/s size 12{"15" "." 0`"m/s"} {} and brought to rest in 2.80 mm. (a) What average force is exerted on the nail? (b) How much is the nail compressed if it is 2.50 mm in diameter and 6.00-cm long? (c) What pressure is created on the 1.00-mm-diameter tip of the nail?

(a) 2 . 01 × 10 4 N size 12{2 "." "01" times "10" rSup { size 8{4} } `N} {}

(b) 1 . 17 × 10 3 m size 12{1 "." "17" times "10" rSup { size 8{ - 3} } `m} {}

(c) 2 . 56 × 10 10 N/m 2 size 12{2 "." "56" times "10" rSup { size 8{8} } `"N/m" rSup { size 8{2} } } {}

Calculate the pressure due to the ocean at the bottom of the Marianas Trench near the Philippines, given its depth is 11.0 km size 12{"11" "." 0`"km"} {} and assuming the density of sea water is constant all the way down. (b) Calculate the percent decrease in volume of sea water due to such a pressure, assuming its bulk modulus is the same as water and is constant. (c) What would be the percent increase in its density? Is the assumption of constant density valid? Will the actual pressure be greater or smaller than that calculated under this assumption?

The hydraulic system of a backhoe is used to lift a load as shown in [link] . (a) Calculate the force F size 12{F} {} the slave cylinder must exert to support the 400-kg load and the 150-kg brace and shovel. (b) What is the pressure in the hydraulic fluid if the slave cylinder is 2.50 cm in diameter? (c) What force would you have to exert on a lever with a mechanical advantage of 5.00 acting on a master cylinder 0.800 cm in diameter to create this pressure?

Diagram of the arm and shovel of a backhoe lifting a load of dirt. The weight of the arm, w sub arm, is depicted as a vector extending vertically downward from the arm one point one zero meters from the top of the arm; w sub arm forms a thirty degree angle with the arm of the shovel. The weight of the load, w sub load, is depicted as a vector extending downward from the middle of the shovel one point seven zero meters from the top of the arm. Force F is a vector pushing the arm of the shovel zero point three zero meters from the top of the arm and perpendicular to the arm.
Hydraulic and mechanical lever systems are used in heavy machinery such as this back hoe.

(a) 1 . 38 × 10 4 N size 12{1 "." "38" times "10" rSup { size 8{4} } `N} {}

(b) 2 . 81 × 10 7 N/ m 2 size 12{2 "." "81" times "10" rSup { size 8{7} } `N} {}

(c) 283 N

Some miners wish to remove water from a mine shaft. A pipe is lowered to the water 90 m below, and a negative pressure is applied to raise the water. (a) Calculate the pressure needed to raise the water. (b) What is unreasonable about this pressure? (c) What is unreasonable about the premise?

You are pumping up a bicycle tire with a hand pump, the piston of which has a 2.00-cm radius.

(a) What force in newtons must you exert to create a pressure of 6 . 90 × 10 5 Pa size 12{6 "." "90" times "10" rSup { size 8{5} } `"Pa"} {} (b) What is unreasonable about this (a) result? (c) Which premises are unreasonable or inconsistent?

(a) 867 N

(b) This is too much force to exert with a hand pump.

(c) The assumed radius of the pump is too large; it would be nearly two inches in diameter—too large for a pump or even a master cylinder. The pressure is reasonable for bicycle tires.

Consider a group of people trying to stay afloat after their boat strikes a log in a lake. Construct a problem in which you calculate the number of people that can cling to the log and keep their heads out of the water. Among the variables to be considered are the size and density of the log, and what is needed to keep a person’s head and arms above water without swimming or treading water.

The alveoli in emphysema victims are damaged and effectively form larger sacs. Construct a problem in which you calculate the loss of pressure due to surface tension in the alveoli because of their larger average diameters. (Part of the lung’s ability to expel air results from pressure created by surface tension in the alveoli.) Among the things to consider are the normal surface tension of the fluid lining the alveoli, the average alveolar radius in normal individuals and its average in emphysema sufferers.

Questions & Answers

A golfer on a fairway is 70 m away from the green, which sits below the level of the fairway by 20 m. If the golfer hits the ball at an angle of 40° with an initial speed of 20 m/s, how close to the green does she come?
Aislinn Reply
cm
tijani
what is titration
John Reply
what is physics
Siyaka Reply
A mouse of mass 200 g falls 100 m down a vertical mine shaft and lands at the bottom with a speed of 8.0 m/s. During its fall, how much work is done on the mouse by air resistance
Jude Reply
Can you compute that for me. Ty
Jude
what is the dimension formula of energy?
David Reply
what is viscosity?
David
what is inorganic
emma Reply
what is chemistry
Youesf Reply
what is inorganic
emma
Chemistry is a branch of science that deals with the study of matter,it composition,it structure and the changes it undergoes
Adjei
please, I'm a physics student and I need help in physics
Adjanou
chemistry could also be understood like the sexual attraction/repulsion of the male and female elements. the reaction varies depending on the energy differences of each given gender. + masculine -female.
Pedro
A ball is thrown straight up.it passes a 2.0m high window 7.50 m off the ground on it path up and takes 1.30 s to go past the window.what was the ball initial velocity
Krampah Reply
2. A sled plus passenger with total mass 50 kg is pulled 20 m across the snow (0.20) at constant velocity by a force directed 25° above the horizontal. Calculate (a) the work of the applied force, (b) the work of friction, and (c) the total work.
Sahid Reply
you have been hired as an espert witness in a court case involving an automobile accident. the accident involved car A of mass 1500kg which crashed into stationary car B of mass 1100kg. the driver of car A applied his brakes 15 m before he skidded and crashed into car B. after the collision, car A s
Samuel Reply
can someone explain to me, an ignorant high school student, why the trend of the graph doesn't follow the fact that the higher frequency a sound wave is, the more power it is, hence, making me think the phons output would follow this general trend?
Joseph Reply
Nevermind i just realied that the graph is the phons output for a person with normal hearing and not just the phons output of the sound waves power, I should read the entire thing next time
Joseph
Follow up question, does anyone know where I can find a graph that accuretly depicts the actual relative "power" output of sound over its frequency instead of just humans hearing
Joseph
"Generation of electrical energy from sound energy | IEEE Conference Publication | IEEE Xplore" ***ieeexplore.ieee.org/document/7150687?reload=true
Ryan
what's motion
Maurice Reply
what are the types of wave
Maurice
answer
Magreth
progressive wave
Magreth
hello friend how are you
Muhammad Reply
fine, how about you?
Mohammed
hi
Mujahid
A string is 3.00 m long with a mass of 5.00 g. The string is held taut with a tension of 500.00 N applied to the string. A pulse is sent down the string. How long does it take the pulse to travel the 3.00 m of the string?
yasuo Reply
Who can show me the full solution in this problem?
Reofrir Reply
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply
Practice Key Terms 5

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Physics of the world around us. OpenStax CNX. May 21, 2015 Download for free at http://legacy.cnx.org/content/col11797/1.1
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Physics of the world around us' conversation and receive update notifications?

Ask