<< Chapter < Page Chapter >> Page >
h = v 0 y 2 2 g . size 12{y= { {v rSub { size 8{0y} } rSup { size 8{2} } } over {2g} } "." } {}

This equation defines the maximum height of a projectile and depends only on the vertical component of the initial velocity.

Defining a coordinate system

It is important to set up a coordinate system when analyzing projectile motion. One part of defining the coordinate system is to define an origin for the x size 12{x} {} and y size 12{y} {} positions. Often, it is convenient to choose the initial position of the object as the origin such that x 0 = 0 size 12{x rSub { size 8{0} } =0} {} and y 0 = 0 size 12{y rSub { size 8{0} } =0} {} . It is also important to define the positive and negative directions in the x size 12{x} {} and y size 12{y} {} directions. Typically, we define the positive vertical direction as upwards, and the positive horizontal direction is usually the direction of the object’s motion. When this is the case, the vertical acceleration, g size 12{g} {} , takes a negative value (since it is directed downwards towards the Earth). However, it is occasionally useful to define the coordinates differently. For example, if you are analyzing the motion of a ball thrown downwards from the top of a cliff, it may make sense to define the positive direction downwards since the motion of the ball is solely in the downwards direction. If this is the case, g size 12{g} {} takes a positive value.

Calculating projectile motion: hot rock projectile

Kilauea in Hawaii is the world’s most continuously active volcano. Very active volcanoes characteristically eject red-hot rocks and lava rather than smoke and ash. Suppose a large rock is ejected from the volcano with a speed of 25.0 m/s and at an angle 35.0º size 12{"35"°} {} above the horizontal, as shown in [link] . The rock strikes the side of the volcano at an altitude 20.0 m lower than its starting point. (a) Calculate the time it takes the rock to follow this path. (b) What are the magnitude and direction of the rock’s velocity at impact?

The trajectory of a rock ejected from a volcano is shown. The initial velocity of rock v zero is equal to twenty five meters per second and it makes an angle of thirty five degrees with the horizontal x axis. The figure shows rock falling down a height of twenty meters below the volcano level. The velocity at this point is v which makes an angle of theta with horizontal x axis. The direction of v is south east.
The trajectory of a rock ejected from the Kilauea volcano.

Strategy

Again, resolving this two-dimensional motion into two independent one-dimensional motions will allow us to solve for the desired quantities. The time a projectile is in the air is governed by its vertical motion alone. We will solve for t size 12{t} {} first. While the rock is rising and falling vertically, the horizontal motion continues at a constant velocity. This example asks for the final velocity. Thus, the vertical and horizontal results will be recombined to obtain v size 12{v} {} and θ v size 12{θ rSub { size 8{v} } } {} at the final time t size 12{t} {} determined in the first part of the example.

Solution for (a)

While the rock is in the air, it rises and then falls to a final position 20.0 m lower than its starting altitude. We can find the time for this by using

y = y 0 + v 0 y t 1 2 gt 2 . size 12{y=y rSub { size 8{0} } +v rSub { size 8{0y} } t - { {1} over {2} } ital "gt" rSup { size 8{2} } "."} {}

If we take the initial position y 0 size 12{y rSub { size 8{0} } } {} to be zero, then the final position is y = 20 .0 m . size 12{y= - "20" "." 0" m" "." } {} Now the initial vertical velocity is the vertical component of the initial velocity, found from v 0 y = v 0 sin θ 0 size 12{v rSub { size 8{0y} } =v rSub { size 8{0} } "sin"θ rSub { size 8{0} } } {} = ( 25 . 0 m/s size 12{"25" "." "0 m/s"} {} )( sin 35.0º size 12{"sin 35"°} {} ) = 14 . 3 m/s size 12{"14" "." "3 m/s"} {} . Substituting known values yields

20 . 0 m = ( 14 . 3 m/s ) t 4 . 90 m/s 2 t 2 . size 12{ - "20" "." 0" m"= \( "14" "." 3" m/s" \) t - left (4 "." "90"" m/s" rSup { size 8{2} } right )t rSup { size 8{2} } "."} {}

Rearranging terms gives a quadratic equation in t size 12{t} {} :

4 . 90 m/s 2 t 2 14 . 3 m/s t 20.0 m = 0. size 12{ left (4 "." "90"" m/s" rSup { size 8{2} } right )t rSup { size 8{2} } - left ("14" "." "3 m/s" right )t - left ("20" "." 0" m" right )=0.} {}

This expression is a quadratic equation of the form at 2 + bt + c = 0 size 12{ ital "at" rSup { size 8{2} } + ital "bt"+c=0} {} , where the constants are a = 4.90 , b = 14.3 , and c = 20.0. Its solutions are given by the quadratic formula:

Practice Key Terms 7

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Cc test coll. OpenStax CNX. Dec 15, 2015 Download for free at http://legacy.cnx.org/content/col11717/1.4
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Cc test coll' conversation and receive update notifications?

Ask