0.2 Developing the array model and processing techniques  (Page 2/2)

If you want to have any chance of figuring out some useful information about a signal, particularly in real-time, you're going to have to ditch the pencil and paper for some electronic equipment. We used National Instruments'LabVIEW 7.1 to do all of our signal processing, although we performed some analog conditioning on the received signal before the analog to digital conversion (ADC). We also used National Instruments'6024e data acquisition card to digitize the signal. This is a multiplexed ADC with a total sampling capacity of 200 kHz that divides between the number of inputs. Therefore, with six sensor inputs, we could sample the signals received at each microphone at a maximum rate of 33.3 kHz. Since twice the Nyquist rate for speech is about 44.1 kHz, this is not a good DAQ for speech applications; however, it would have worked for our original plan to listen to low frequency sound in the 0 to 8 kHz range. As it turns out, since our array can process a maximum frequency of 1600 Hz, we chose to sample at $f_s=4000\mathrm{Hz}$ , which exceeds the Nyquist requirement and is well within the capability of our DAQ.

All of these properties generealize to determining the design of any ULA or the design of any array, though other designs may have greater capabilities and thus would require that you consider additional signal properties (e.g., signal elevation above or below the array) and how they affect the array. If you need a starting point, think about the range of frequencies that you are interested in and get equipment that is capable of processing them. That includes an ADC that can sample at a high enough rate to avoid temporal aliasing and the materials to construct an array such that spatial aliasing will not occur. You will probably have to do some pre-conditioning of the signal before you digitize it, such as lowpass filtering to reject frequencies above those you are interested in and applying a gain to the input signals. These are all important things to think about when you design your array!

Ula processing fundamentals

Now it's time to look at the theory that we need to implement for a ULA that enables us to figure out where signals come from and to listen to them. We are considering narrowband signals (i.e., sinusoids) of the form

Now we need to do some Fourier transforms to look at the frequency content of our received signals. Even though each sensor receives the same frequency signal, recall that delays $x\left(t-n\tau \right)$ in time correspond to modulation by $e^{-jn\tau }$ in frequency, so the spectra of the received signals at each sensor are not identical. The first Discrete Fourier Transform (DFT) looks at the temporal frequency content at each sensor:

Now that we have N spectra from each of the array's sensors, we are interested to see how a certain frequency of interest fo is distributed spatially. In other words, this spatial Fourier transform will tell us how strong the frequency fo for different angles with respect to the array's broadside. We perform this DFT by taking the frequency component from each received signal that corresponds to fo and concatenating them into an array. We then zero pad that array to a length that is a power of two in order to make the Fast Fourier Transform (FFT) computationally efficient. (Every DFT that we do in this project is implemented as an FFT. We use the DFT in developing the theory because it applies always, whereas the FFT is only for computers.)

Recalling that we zero padded our array of coefficients corresponding to $f_0$ , what has that done for us in terms of the spatial spectrum? Well, we have improved our resolution, which means that the spectrum is smoother and more well-defined. This is because we are able to see the frequency differences for smaller angles. If we increase the actual number of sensors in the array, we will also improve our resolution and we will improve the beamforming by increasing the magnitude of the main lobe in the sinc spectrum and decreasing the magnitudes of the side lobes.