For SHM to occur we require stable equilibrium, about a point. For example, at
the origin we could have:
which
would describe a system in equilibrium. This however is not necessarily stableequilibrium.
The lower part of the figure shows the case of unstable equilibrium. The upper
part shows the case of stable equilibrium. These situations often occur inmechanical systems.
For example, consider a mass attached to a spring:
In general, in a case of stable equilibrium we can write the force as a
polynomial expansion:
where
the
are positive constants. There is always a region of
small enough that we can write:
This is satisfied by an equation of the form
where
and
are constants that are determined by the initial conditions.
Draw a diagram of a sinusoid and mark on it the period T and Amplitude A
Is an arbitrary phase which shifts the sinusoid.This is also
satisfied by an equation of the form
Lets
show this:
Again
there are two constants determined by the initial conditions
and
The equation can be rewritten
Thus
if
then
the equation is identical to the SHM equation.
So another way to write the equation of Simple Harmonic Motion is
or
It is also important to remember the relationships between freqency, angular
frequency and period:
Another solution to the SHM equation is
Recall Taylor's expansions of sine and cosine
Then
(an alternative way to show this is the following)
Thus we can write
as
We will use the complex representation a lot, so you need to
become familiar with it. It is used a lot in Optics, Classical and QuantumMechanics and Electrical Engineering so it is a good thing to know.
Now for physical systems we are interested in just the realpart so
This
will be implicitly understood. In physics we just write
One thing that will seem to be confusing is that there are all these different
solutions. They are all just different forms of the same thing. Which form isused in a particular circumstance is simply a matter of convenience. Some
forms lend themselves to to solutions of certain problems more easily thanothers. Also the most convenient form can depend upon the initial conditions.
For example if
is at its maximum displacement at time
then a
form may be the most convenient. As a general rule I like using the complex
representation because natural logarithms are so easy to work with. Forexample
which
is all pretty simple to remember