<< Chapter < Page Chapter >> Page >

Instruments to measure voltage, current and resistance

As we have seen in previous sections, an electric circuit is made up of a number of different components such as batteries, resistors andlight bulbs. There are devices to measure the properties of these components. These devices are called meters.

For example, one may be interested in measuring the amount of current flowing through a circuit using an ammeter or measuring the voltage provided by a battery using a voltmeter . In this section we will discuss the practical usage of voltmeters, ammeters, and ohmmeters .

Voltmeter

A voltmeter is an instrument for measuring the voltage between two points in an electric circuit. In analogy with a water circuit, avoltmeter is like a meter designed to measure pressure difference. Since one is interested in measuring the voltage between twopoints in a circuit, a voltmeter must be connected in parallel with the portion of the circuit on which the measurement is made.

A voltmeter should be connected in parallel in a circuit.

[link] shows a voltmeter connected in parallel with a battery. One lead of the voltmeter is connectedto one end of the battery and the other lead is connected to the opposite end. The voltmeter may also be used to measure thevoltage across a resistor or any other component of a circuit that has a voltage drop.

Ammeter

An ammeter is an instrument used to measure the flow of electric current in a circuit. Since one is interested in measuring thecurrent flowing through a circuit component, the ammeter must be connected in series with the measured circuit component ( [link] ).

An ammeter should be connected in series in a circuit.

Ohmmeter

An ohmmeter is an instrument for measuring electrical resistance. The basic ohmmeter can function much like an ammeter. The ohmmeterworks by suppling a constant voltage to the resistor and measuring the current flowing through it. The measured current is thenconverted into a corresponding resistance reading through Ohm's Law. Ohmmeters only function correctly when measuring resistance over a componentthat is not being powered by a voltage or current source. In other words, you cannot measure the resistance of a component that isalready connected to a live circuit. This is because the ohmmeter's accurate indication depends only on its own source ofvoltage. The presence of any other voltage across the measured circuit component interferes with the ohmmeter'soperation. [link] shows an ohmmeter connected with a resistor.

An ohmmeter should be used when there are no voltages present in the circuit.

Meters impact on circuit

A good quality meter used correctly will not significantly change the values it is used to measure. This means that an ammeter hasvery low resistance to not slow down the flow of charge. A voltmeter has a very high resistance so that it does not add another parallel pathway to the circuit for the charge to flow along.

Investigation : using meters

If possible, connect meters in circuits to get used to the use of meters tomeasure electrical quantities. If the meters have more than one scale, always connect to the largest scale first so that the meter will not be damaged by having to measure values that exceed itslimits.

The table below summarises the use of each measuring instrument that we discussed and the way it should be connected to a circuitcomponent.

Instrument Measured Quantity Proper Connection
Voltmeter Voltage In Parallel
Ammeter Current In Series
Ohmmeter Resistance Only with Resistor

Khan academy video on circuits - 4

The following presentation summarizes the concepts covered in this chapter.

Exercises - electric circuits

  1. Write definitions for each of the following:
    1. resistor
    2. coulomb
    3. voltmeter
  2. Draw a circuit diagram which consists of the following components:
    1. 2 batteries in parallel
    2. an open switch
    3. 2 resistors in parallel
    4. an ammeter measuring total current
    5. a voltmeter measuring potential difference across one of the parallel resistors
  3. Complete the table below:
    Quantity Symbol Unit of meaurement Symbol of unit
    e.g. Distance e.g. d e.g. kilometer e.g. km
    Resistance
    Current
    Potential difference
  4. [SC 2003/11] The emf of a battery can best be explained as the
    1. rate of energy delivered per unit current
    2. rate at which charge is delivered
    3. rate at which energy is delivered
    4. charge per unit of energy delivered by the battery
  5. [IEB 2002/11 HG1] Which of the following is the correct definition of the emf of a battery?
    1. It is the product of current and the external resistance of the circuit.
    2. It is a measure of the cell's ability to conduct an electric current.
    3. It is equal to the “lost volts” in the internal resistance of the circuit.
    4. It is the power supplied by the battery per unit current passing through the battery.
  6. [IEB 2005/11 HG] Three identical light bulbs A, B and C are connected in an electric circuit as shown in the diagram below.
    1. How bright is bulb A compared to B and C?
    2. How bright are the bulbs after switch S has been opened?
    3. How do the currents in bulbs A and B change when switch S is opened?
      Current in A Current in B
      (a) decreases increases
      (b) decreases decreases
      (c) increases increases
      (d) increases decreases
  7. [IEB 2004/11 HG1] When a current I is maintained in a conductor for a time of t , how many electrons with charge e pass any cross-section of the conductor per second?
    1. It
    2. It/e
    3. Ite
    4. e/It

Questions & Answers

A golfer on a fairway is 70 m away from the green, which sits below the level of the fairway by 20 m. If the golfer hits the ball at an angle of 40° with an initial speed of 20 m/s, how close to the green does she come?
Aislinn Reply
cm
tijani
what is titration
John Reply
what is physics
Siyaka Reply
A mouse of mass 200 g falls 100 m down a vertical mine shaft and lands at the bottom with a speed of 8.0 m/s. During its fall, how much work is done on the mouse by air resistance
Jude Reply
Can you compute that for me. Ty
Jude
what is the dimension formula of energy?
David Reply
what is viscosity?
David
what is inorganic
emma Reply
what is chemistry
Youesf Reply
what is inorganic
emma
Chemistry is a branch of science that deals with the study of matter,it composition,it structure and the changes it undergoes
Adjei
please, I'm a physics student and I need help in physics
Adjanou
chemistry could also be understood like the sexual attraction/repulsion of the male and female elements. the reaction varies depending on the energy differences of each given gender. + masculine -female.
Pedro
A ball is thrown straight up.it passes a 2.0m high window 7.50 m off the ground on it path up and takes 1.30 s to go past the window.what was the ball initial velocity
Krampah Reply
2. A sled plus passenger with total mass 50 kg is pulled 20 m across the snow (0.20) at constant velocity by a force directed 25° above the horizontal. Calculate (a) the work of the applied force, (b) the work of friction, and (c) the total work.
Sahid Reply
you have been hired as an espert witness in a court case involving an automobile accident. the accident involved car A of mass 1500kg which crashed into stationary car B of mass 1100kg. the driver of car A applied his brakes 15 m before he skidded and crashed into car B. after the collision, car A s
Samuel Reply
can someone explain to me, an ignorant high school student, why the trend of the graph doesn't follow the fact that the higher frequency a sound wave is, the more power it is, hence, making me think the phons output would follow this general trend?
Joseph Reply
Nevermind i just realied that the graph is the phons output for a person with normal hearing and not just the phons output of the sound waves power, I should read the entire thing next time
Joseph
Follow up question, does anyone know where I can find a graph that accuretly depicts the actual relative "power" output of sound over its frequency instead of just humans hearing
Joseph
"Generation of electrical energy from sound energy | IEEE Conference Publication | IEEE Xplore" ***ieeexplore.ieee.org/document/7150687?reload=true
Ryan
what's motion
Maurice Reply
what are the types of wave
Maurice
answer
Magreth
progressive wave
Magreth
hello friend how are you
Muhammad Reply
fine, how about you?
Mohammed
hi
Mujahid
A string is 3.00 m long with a mass of 5.00 g. The string is held taut with a tension of 500.00 N applied to the string. A pulse is sent down the string. How long does it take the pulse to travel the 3.00 m of the string?
yasuo Reply
Who can show me the full solution in this problem?
Reofrir Reply
Got questions? Join the online conversation and get instant answers!
Jobilize.com Reply

Get Jobilize Job Search Mobile App in your pocket Now!

Get it on Google Play Download on the App Store Now




Source:  OpenStax, Siyavula textbooks: grade 10 physical science. OpenStax CNX. Aug 29, 2011 Download for free at http://cnx.org/content/col11245/1.3
Google Play and the Google Play logo are trademarks of Google Inc.

Notification Switch

Would you like to follow the 'Siyavula textbooks: grade 10 physical science' conversation and receive update notifications?

Ask