Lab 0: hardware introduction

Introduction

This exercise introduces the hardware and software used in testing a simple DSP system. When you complete it, you shouldbe comfortable with the basics of testing a simple real-time DSP system with the debugging environment you will usethroughout the course. First, you will connect the laboratory equipment and test a real-time DSP system with pre-writtencode to implement an eight-tap (eight coefficient) finite impulse response ( FIR ) filter. With a working system available, you will then beginto explore the debugging software used for downloading, modifying, and testing code. Finally, exercises are included to refresh your familiarity with MATLAB.

Lab equipment

This exercise assumes you have access to a laboratory station equipped with a Texas Instruments TMS320C549 digital signalprocessor chip mounted on a Spectrum Digital TMS320LC54x evaluation board. The DSP evaluation module should beconnected to a PC running Windows and will be controlled using the PC application Code Composer Studio, a debugger anddevelopment environment. Mounted on top of each DSP evaluation board is a Spectrum Digital surround-sound moduleemploying a Crystal Semiconductor CS4226 codec. This board provides two analog input channels and six analog outputchannels at the CD sample rate of 44.1 kHz. The DSP board can also communicate with user code or a terminal emulator runningon the PC via a serial data interface.

In addition to the DSP board and PC, each laboratory station should also be equipped with a function generator to providetest signals and an oscilloscope to display the processed waveforms.

Step 1: connect cables

Use the provided BNC cables to connect the output of the function generator to input channel 1 on the DSP evaluationboard. Connect output channels 1 and 2 of the board to channels 1 and 2 of the oscilloscope. The input and outputconnections for the DSP board are shown in [link] .

Example hardware setup

Note that with this configuration, you will have only one signal going into the DSP board and two signals coming out.The output on channel 1 is the filtered input signal, and the output on channel 2 is the unfiltered input signal.This allows you to view the raw input and filtered output simultaneously on the oscilloscope. Turn on the functiongenerator and the oscilloscope.