Introduction to mechanical measurements

0.1 Introduction:
0.2 Teaching objectives:
0.3 Procedure:
0.4 Part 1: creating a signal with the function generator
0.5 Part 2: analyzing a signal with an oscilloscope
0.8 2.3 setting the horizontal sweep (refer to figure 1)
0.9 2.4 measure features (refer to figure 2)
0.14 2.6 the cursor button (refer to figure 2)
0.15 2.7 the save/recall button (refer to figure 2)
0.17 Part 3: data acquisition
0.25 Part 4: shutting down
2.1 Introduction:
2.8 Operational amplifier (op-amp)
2.11 Part 1: set up the power supply
2.12 Part 2: preparing the breadboard
2.13 Part 3: generate a simulated signal
2.14 Part 4: modify existing vi for multiple inputs
2.15 Part 5: op-amp circuits
2.18 Part 6: bias correction
2.21 Part 7: low-pass filtering
2.27 Part 8: aliasing

Source:  OpenStax, Introduction to mechanical measurements. OpenStax CNX. Oct 18, 2006 Download for free at http://cnx.org/content/col10385/1.1